The Protector” is a great choice for tropical or other waters where extreme fouling exists. With its high load of copper in a durable epoxy base, The Protector” provides multi-season antifouling protection—and isan especially good choice for tropical or other waters where extreme fouling exists. The Protectors modified epoxyformula dries to a hard, abrasion-resistant surface that can if desired be burnished to create a smooth racing surface. With a VOC content of 330g/liter The Protector” meets VOC regulations and is a great choice for fiberglass, wood orsteel hulls. Do not apply to aluminum hulls. Available in Red, Blue and Black. Key Features High copper load maximizes antifouling effectiveness Hard durable finish stands up to abrasion Easily burnished for reduced drag Meets VOC regulations 330 gram per liter Good antifouling choice for tropical and warm waters Physical Data Type: Modified Epoxy/Rosin Finish: Flat Available colors: Blue, Red, Black Components: 1 Curing mechanism: Solvent Release Solids by Volume: 62% +/- 2% (theoretical) Solids by weight: 839 +/- 2% (theoretical) Coverage: 500sq. ft. /gal. VOC: 330 grams/liter (As Supplied and applied) Active ingredients: 53.5% Cuprous Oxide Flash point: 115 F (SETA) Application Application Method: Brush, roller, airless, or conventional spray Number of coats recommended: 2 Wet Film Thickness: 3.3 mils Dry Film Thickness: 2 mils Applicator: High-quality short nap roller (maximum 3/8” nap) brush Application temperature Min. /Max. Range: Minimum 5C/40F and maximum 30C/90F Thinner: 120 Brushing Thinner, Model 249961 Drying Times*(Hours) Drying